Server Technology PT40 Instrukcja Instalacji Pobierz pdf (Strona 62)

62 • Advanced Operations Smart Cabinet Distribution Unit

Installation and Operations Manual

Enabling and Setting up LDAP Support

There are a few configuration requirements for properly enabling and setting up LDAP support. Below

is an overview of the minimum requirements.

Directory Services server configuration requirements:

1. Define at least one LDAP group.

2. Assign users to that LDAP group.

Sentry configuration requirements:

1. Enable LDAP support.

2. Define the IP address and domain component of at least one Directory Services server.

3. Set the LDAP bind request method being utilized by the Directory Services server.

4. Define the IP address of at least one DNS server.

5. Test DNS server configuration using Sentry ‘ping’ support.

6. Define at least one LDAP group and assign access rights for that group.

NOTE: LDAP group names on the Directory Service server and the Sentry must match.

Enabling and disabling LDAP support:

The Set LDAP command is used to enable or disable LDAP support.

To enable or disable LDAP support:

At the Smart CDU: prompt, type set ldap, followed by enabled or disabled and press Enter.

Setting the LDAP host address:

The Set LDAP Host command sets the TCP/IP address of the Directory Services server.

To set the LDAP host address:

At the Smart CDU: prompt, type set ldap, followed by host1 or host2 and the Directory Services

server’s IP address or hostname. Press Enter.

Examples

The following command sets the primary Directory Services server IP address to 98.76.54.32:

Smart CDU: set ldap host1 98.76.54.32<Enter>

The following command sets the secondary Directory Services server hostname to ldap.servertech.com:

Smart CDU: set ldap host2 ldap.servertech.com<Enter>

Changing the LDAP server port:

The Set LDAP port command sets the port to which the Sentry sends LDAP requests to on the

previously defined LDAP server. The default port is 389.

To change the LDAP server port:

At the Smart CDU: prompt, type set ldap port, followed by the port number and press Enter.

Example

The following command sets the LDAP server port number to 8888:

Smart CDU: set ldap port 8888<Enter>

Enabling and disabling LDAP over TLS/SSL support:

The Set LDAP UseTLS command is used to enable or disable LDAP over TLS/SSL support.

To enable or disable LDAP over TLS/SSL support:

At the Smart CDU: prompt, type set ldap usetls, followed by yes or no and press Enter.

NOTE: If LDAP over TLS/SSL is enabled, MD5 binding is disabled.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 89 90

Komentarze do niniejszej Instrukcji

Brak uwag

Server Technology PT40 Instrukcja Instalacji Strona 62

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Server Technology PT40